Most recent activity
-
What size is it ? Cheers
-
2 x Veloce 9 speed casssettes and wheelset added. Pics to follow
-
Normally I'd ignore it but the corrosion is pretty bad in certain areas, the clear has completely bubbled up and detached in places - look at the state of the rear brake bridge, so it needs protecting . Surprised this would be used as a factory finish as it's not proven durable ( Kona tech support told me it's normal patina that would be under opaque paint as well - pretty sure thats not true! A primer should protect the frame beneath a top coat )
-
Nice set up: £60 for the lot
Deda Peiga 44cm bars have only seen few months use.
ITM in lesser seen black finish 110mm length
Cane Creek SCR 5 levers - same shape as Campagolo 2nd gen, most comfortable single speed levers I have used. Hoods in great shape.
Located in Bristol or can post at cost.
-
Dibs 3t stem, tektro deep drops and the trek saddle. PM sent cheers
Edit- sorry didn't see @sacredhart had already asked about the saddle!
-
Has anyone got experience dealing with rust under clear coat on a raw frame? Picked up this Kona recently 2nd hand and it's more extensive than I thought. I'm reluctant to let it get any worse.
Considering using a wire brush drill attachment to remove the rust and then use clear nail varnish) spray clearcoat , but have tested a small area and the wire brush completely strips away the dark grey finish. I'm note sure if the steel will darken again with time or it's a tint in the clear coat ..
Any other suggestions ?
Cheers
Thanks, a bit small for me. GLWS