Using this time to skill up on bikes and have been using this forum a lot plus YouTube.
My girlfriend wanted bullhorns on hers so gave it a go myself with bars and new brake levers from BLB. They had to replace the old levers as they didnt have a hinge so couldnt get them onto the bar.
I fitted them all correctly (I think) with the only issue being the cables which took up a bit of time reading online. They cable stopper doesnt fit into the hole so sticks out quite unsightly into the handle area - circled on the pic. In fact the stopper doesnt even reach the lever before the thicker inside bit.
Have I done anything wrong?
Also taping handle bars is tough but the plugs they gave me dont fit properly into the bar. They can fall out so easily but I have tape over the end holding it in place.
Loving this journey!