Can anyone recommend a cheap engineer/machinist in Oxford?
As per Tester's instructions, I need a couple of small holes drilled and tapped(?) in my seat post clamp and I wondered if anyone knew of anyone who would be prepared to take on such a small job?
I may be able to help. What type of material is this and what thread size do you need tapped?
Nevermind. Just took a close look at the picture. This is what I get for being up early
No point helping , all the gear no idea ^^
Don't worry about formatting, just type in the text and we'll take care of making sense of it. We will auto-convert links, and if you put asterisks around words we will make them bold.
For a full reference visit the Markdown syntax.
© LFGSS, powered by microcosm.
Report a problem
A community of cyclists.