You are reading a single comment by @moog and its replies. Click here to read the full conversation.
  • or for a slightly less DIY version

    • make a pattern out of high density modelling foam (or some other type of modelling board) of your perfect saddle
    • get a saddle and trim it down to the bare minimum (maybe a central spine with wings which the rails are attached to)
    • machine the bottom of the pattern so that the cut down saddle fits in it
    • make a silicon mould of the pattern *
    • vacuum cast your new saddle top using a resin *
    • glue new saddle top to existing saddle carcass
    • cover if you wish

    • if you are serious about this I can probably do the above tasks, it isn't cheap though mind.

About

Avatar for moog @moog started