You are reading a single comment by @ElGonzo and its replies.
Click here to read the full conversation.
ElGonzo
-
Thank you! That looks perfect. Will get a bottle ordered.
@Glws it is a BB90 on these, so limited to 24mm spindle cranks. I got the bearings out yesterday and have had the Campag adapter kit curing overnight based on the guide here. I'm not going to go any further with the BB/crank until I've run the EPS wires however.
@lesterama that looks a useful product too, although the paint looks pretty good from a distance when I get up close there are a lot of fine swirls so I think something like that once I've got it cleaned up will hopefully bring the colour back to life and get it popping a bit more.
ASTTer
I've been attempting to clean the frame up and drawing a blank at getting the black marks pictured below off. I've tried muc off bike cleaner and isopropyl with no luck. I can feel the marks when I run a nail over them so might need something with a bit more friction than a cloth to get them off. A couple of people have suggested tar remover or a clay bar, but any suggestions would be much appreciated!