You are reading a single comment by @Hulsroy and its replies.
Click here to read the full conversation.
-
Thank you. Yes that is the plan for now.
The stainless axle receiver is turned on the lathe and then TIG welded onto the flatplate dropout on both side. The two-holed flange is silver soldered onto the dropout when then dropouts have been brazed to the frame. By chamfering the backside of the bigger hole in that flange I should be able to get it flush with the DS dropout face. Gear hangers can then be out of stainless or alu depending on what I can get lasercut.
All of this is heavily inspired by Hunter Cycles but optimised for my workflow and fab preferences.
1 Attachment
-
Hulsroy
Cupcakes
Neat. Are the two pink parts brazed together? Is there some kind of locking geometry between the hanger and the tab?