You are reading a single comment by @HatBeard and its replies.
Click here to read the full conversation.
-
Somehow the stickiness issue spread to my other plate, swapped in a resin plate i was sent to review and full plate thin walled print is sticking to it perfectly, faultless first layer, no warping.
No idea what is up with the two textured plates though. Been working fine up until now and my printing activity is very low volume.
HatBeard-
Definitely odd.
No doubt you're using the same filament, and you've probably checked the bed always heats uniformly and the Z axis sensor is working correctly? (past problems with my ageing Prusa clone!)
At one time I had issues with a cleaner at work using Pledge - the overspray seemed to go everywhere - but I guess you'd notice that kind of contamination at home.
MrE
Scrub with wet baking soda (mainly for it's mild abrasive qualities) - rinse - wipe with spirit vinegar (chemistry) - rinse (distilled water if possible) - clean once more with isopropyl alcohol - if things still don't stick, you'll probably need your other textured plate...