Rear Derailleur Hanger Identification - Dan Smith DOS Columbus Steel Frameset

You are reading a single comment by @Chaley and its replies. Click here to read the full conversation.

•

oheyitsd

I'm lost now to be honest. The PILO one does have a little indent along that line though, so it wouldn't be too difficult to machine it along that line. You could get most of it off with a dremel and then the rest with a file.

I'm kind of even wondering if the WM one just looks 180 because the image has been flipped. It looks like it's being attached to the NDS in the image. Don't take my word though

•

Chaley in reply to @oheyitsd

WM are good at showing which side the hanger mounts tbh. If you are filling a flat you have to make 100% sure it’s parallel to stop poor shifting.

•

Kimmo in reply to @Chaley

Not really - it doesn't have to be filed absolutely perfectly; you just have to do what you'd do whenever you fit a new hanger, and check its alignment.

About

Avatar for Chaley @Chaley started