You are reading a single comment by @Benzo and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Benzo
Hey All,
Currently struggling to remove headset cups from a 1 inch headset and a 46cm frame with a short headtube.
Think because the tube is so short the "prongs" (not the correct word) don't stretch back out after going through the upper cup so are not gripping the lower cups and just go straight through.
Using the Park Tools Remover for reference.
Have tried inserting a socket set bit to try to stretch out prongs and hold in place however didn't have any luck.
Well aware I've worded this particularly badly so any advice would be much appreciated.