You are reading a single comment by @jackbepablo and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@jackbepablo
So, I got a set of P-Rails in Triple Shot Rings, ready to fit. I have wired them in, pretty easy stuff in the end – especially since the rings and pickups were already set up, it was a like-for-like job.
However the bridge PU is pretty weedy compared to the neck (which is all I'd dreamed of). I've got in touch with the retailer but can anyone in here think of anything obvious that could be causing this?
I checked over my wiring/soldering again yesterday, made sure the pickups werent pinching the PCB, etc etc. All seems fine, I even swapped out the capacitor for my neck PU to match the aftermarket one I'd already fitted to the bridge, just to be sure.