You are reading a single comment by @Velocio and its replies.
Click here to read the full conversation.
-
Yeah, small wins... feels like co-ordinating that would be more overhead than just going sequential at a faster rate. Those sections don't seem to yield enough benefit... and too many hands reaching for pieces and too much back and forth on the instructions might cost a lot more than any benefit from those sections.
Velocio
I can see quite a few sub-sections that could be built independently.
For example the bits starting at 29, 53, 96 (rear bumper), 117 (engine), 132 (seats), 155 (front axle), 188 (rear bodywork), 222 (doors), 264 (windscreen), 296 (bonnet). etc...
Might be tricky to estimate how long each of those will take and divvy them up accordingly.