You are reading a single comment by @chiroshi and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of fixed gear and single-speed cyclists.
@chiroshi
I had my first go at rendering yesterday. I used a pre-mixed bucket, which seems to be the most common way here. Took a few minutes to get the hang of getting it to stick to the wall without dropping half of it on the floor. Time will tell if it's adhered enough, but I did all the right steps according to the instructions.
Only doing a ~30cm strip at floor level was a royal pain though. I'll cover most of of it up with pebbles too to try and hide those conduits. Why they're above ground is a long story, but it was basically unavoidable to sink them without a large amount of excavation. They were already at ground level when I built the lean-to shed.
1 Attachment