You are reading a single comment by @pdlouche and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@pdlouche
Enlarged the drill hole and as feared, tank is flush against the flooring. So even dead-careful and it bit the tank.
So ABS filament (from a friend’s 3D printer) went in, and then my ABS/Acetone suspension on top to melt the tank into a chemical bond.
I won’t know if it worked until it has totally dried, which is a couple hours if I rush, or tomorrow if I want to be safe and conservative.
3 Attachments