Do they go bigger than 160mm??
From your photos, it looks like you have flat mount, so probably not. I didn't know whether you were using 140mm. If you're desperate, then you could also wind the inboard all the way out, so the disc isn't centered in the caliper but is still centered between pads. Or use a half worn pad on the inside. Or shim the rotor. I would prefer any of those solutions over shimming the hub end caps.
Yes its flat mount. I've just tried shimming the rotor which has helped. will wind the pads to see if that helps cheers.
+1 for winding in the inboard pad.
Then going shimano hydraulic.
© LFGSS, powered by microcosm.
Report a problem
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.