So them SJS slash Jtek slash whoever canti racks… anyone had any luck fitting one to a suspension-corrected fork?
The fork crown on my Troll is a few cm higher than is typical, and as such the short part of the stock bracket is too, well, short. Before I start hammering and bending and all that, any tips?
Instead of bending, use a bit of metal to extend the bracket. I used something I already had in the toolbox.
© LFGSS, powered by microcosm.
Report a problem
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.