You are reading a single comment by @Skülly and its replies. Click here to read the full conversation.
  • I have these hubs as well and didn't realise you could just take them apart. how did you get the axle out?

  • I have these hubs as well and didn't realise you could just take them apart. how did you get the axle out?

    I love this comment, because I totally get that feeling. Was taught to strip a hope on a mechanics course and it really is like a skate wheel but with holes for spokes where there might be urethane. Magnets, magic, demons, gyroscopes, what do we think is going on in there?

  • yeah, it totally makes sense that if the internal diameter of the shell is the same, then you can use the TA bearings and endcaps. i didn't even consider that was a possibility until i saw this thread.

    but, but, but... how do you get the qr axle out? support the shell at one end and bang the axle with a hammer at the other?

About

Avatar for Skülly @Skülly started