I've just had a front wheel built up using a QR front hub assuming I could change the QR to 12mm bolt through however it appears I can't - unless I'm mistaken?
Before I buy another hub and get it rebuilt does anybody know if there is way?
Hub reference is H350ACQXR28SA4683S
I had a quick look at the manuals and it does look like the axle itself it's QR only. Don't see a way other than swapping the axle out, but that may not be possible.
Not possible, I am afraid.
The front hub can be changed from thru axle to QR but not the other way round.
Remove the QR cap and measure the inner diameter of the sealed bearing and you can see it's smaller than 12mm so no possibility to slide a thru axle.
I also found out the hard way and had to rebuild the front wheel.
© LFGSS, powered by microcosm.
Report a problem
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.