You are reading a single comment by @Saffronspokes and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Saffronspokes
Getting a really solid result on a 3D printed piece of ti is quite difficult as there's quite a lot of small dimples in there. I've seen some examples of polished 3D printed ti before and I wasn't blown away to be honest. I think you made the right choice by staying with this finish as the end result is homogeneous.