You are reading a single comment by @yoshy and its replies.
Click here to read the full conversation.
-
any particular length?
Whatever you assumed in your calculation. danstuff's recent experience suggests sticking to the spoke manufacturer's nipples to be on the safe side, which you may get with the spokes from some shops when you're buying spokes individually.
Personally, I like building with the DT Hex nipples just because it's quicker to get the hex driver onto the nipple than it is to engage a conventional spoke key on the square.
gbj_tester
@yoshy
Fair enough, was just going off what's on Sheldon
I forgot to ask about nipples, any particular length?
I was looking at these
https://www.sjscycles.co.uk/spokes/12-sapim-polyax-nipples-plated-brass-2mm-gauge-pack-of-100/