Yes. I guess an alternative would be to split that section and have two pieces going up and down at ninety degrees (or more) from your central extrusion.
The heat from brazing causes the tubes to expand and contract and as the heat is focused on one side at a time, this has the effect of pulling the tube one way, out of line.
Apparently, since the jig holds it all together, the tube will pull but be held in place and when the fillets cool, you'll have built tensions into the frame which can cause cracking or failures in the future.
Don't think any framebuilders will braze a full frame in a jig, just tack as M_V says.
(This is what I have read, I don't have enough experience to say either way)
Back in the early 90's when cheap lugged 501 frames were mass produced this was a common failure mode, e.g crack s between head tube lug and shifter boss.... Raleigh, falcon, Holdsworth etc brazed in jigs by factory workers
© LFGSS, powered by microcosm.
Report a problem
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.