You are reading a single comment by @Hovis and its replies. Click here to read the full conversation.
  • Interesting. I'm not very good with really understanding these vapour barriers. So what would happen if I leave the gaps open? Isn't the fact there is a continuous vapour barrier behind mean the water won't condense there? I have trickle vents on the bifold doors in case that helps. At the end of day surely it's impossible to make it gapless? Eg bottom of the walls clearance from floor / skirting. Normally that's caulked against wall and under skirting will have a little gap with the floor.

    Let me know your thoughts, I don't want to balls this up at this stage. Thanks.

  • Looks great.
    So - did you leave gaps?
    I'll try and give an explanation of how I think the vapour thing works...
    The interior space is warm and humid (relatively), so there is usually a pressure from inside to out. Your warm humid air is trying to get out through the walls. If it gets into the bit with insulation, then as it passes through the insulation the temperature drops and you get condensation. The middle of walls is a bad place for that to happen, that's why you use a vapour barrier on the warm side of the insulation - so that water vapour can't get there. But vapour barrier won't stop condensation on the room side of it, it's to stop vapour getting through. Although it's the warm side of the insulation, the face of the wall is still a bit colder than the interior of the room, so the theory about sealing the ply with more permeable silicon is that the vapour will pass through the joints (due to the general low-level pressure for air to try and get out through the walls), and because the joints are more or less sealed, it can't ventilate out again, so it's stuck there getting damp between your ply and the vapour barrier. If you leave actual gaps, air should be circulating enough that you don't get a build up of damp/condensation.


Avatar for Hovis @Hovis started