Workshop tooling and equipment boast posts.

You are reading a single comment by @PhilDAS and its replies. Click here to read the full conversation.

•

Jingle_Jangle in reply to @PhilDAS

I haven't done that yet.

I am aware that this fixture requires a bit of user-input to get it up and running, and that I need to fabricate (or cause to have fabricated) some bits out of mild steel.

Will do the 'un-boxing' at the weekend, and then see what has to be done.

Also, need to get a surface plate.

•

PhilDAS in reply to @Jingle_Jangle

How’s the fixture looking?

Wanted
If anyone here has an old or surplus frame/fork/chainstay jig, dummy axles etc, I’d like to buy some stuff. I realise we have only hobbyists on here for the most part (the @coldharbour excluded) and are unlikely to have spares but shout if anyone sees anything too.

•

Jingle_Jangle in reply to @PhilDAS

Fixture is still in the box :(

It requires me to source a few lengths of box section steel to put it together, and work / parenting / life / poverty have all conspired to make me fail.

Must try harder.
•

mike_mcdermid in reply to @PhilDAS

i might have some bits and bobs kicking about

About

Avatar for PhilDAS @PhilDAS started