Hulsroy's Hustle

You are reading a single comment by @Hulsroy and its replies. Click here to read the full conversation.

•

MisterMikkel in reply to @Hulsroy

Other than examining the tool paths, you could do a dry run in model foam, wood or some other cheap/lightweight material.

•

Hulsroy in reply to @MisterMikkel

Yes. But running a graphic simulation would have been enough. I have 3d prints of it to determine form.

•

MisterMikkel in reply to @Hulsroy

I see.. I was mainly suggesting it to check the tool path, not form.

About

Avatar for Hulsroy @Hulsroy started