Ceeway group ordering.

You are reading a single comment by @M_V and its replies. Click here to read the full conversation.

•

PhilDAS in reply to @M_V

Holding it in place is my biggest concern. With welding you could just put a wheel in the dropouts, bolt a caliper to the mount, pull the lever and it grabs the rotor, then tack. Brazing it without a jig or precise measurements sounds much harder

•

M_V in reply to @PhilDAS

With these forks I'm doing the mounts on, I considered going down the disc brake route and I thought I could arc weld it in a couple spots to tack and then fill the rest with braze. I have a cheap arc welder but it's not neat enough to do the whole job.

•

PhilDAS in reply to @M_V

Right oh. So I think without a workshop and proper tooling, I should approach it that way.
Buy mount, find someone willing to let me use their welder or do it for me. Tack each end of the mount and then give brazing a bash to really glue it on

About

Avatar for M_V @M_V started