You are reading a single comment by @rodabod and its replies.
Click here to read the full conversation.
-
I looked up "ele4207" and the pictures suggest that you are looking at the fixed ends (possibly riveted) of two bolts. It looks as if nuts would be secured on the opposite side.
Are you sure you can't reach the connectors to the rear of the oven?
rodabod-
Thanks, I'd only found pictures with holes when I searched! I'll have another look behind the oven but it looks as if the whole back panel will need to come off, which will be tricky as it's between two worktops. Didn't see any sort of service hatch before either.
Manufacturer is defunct and obscure even when in production, so haven't managed to find any sort of service manual either.
Dramatic_Hammer
Next piece of shitty Italian 'engineering':
Fratelli Onofri Imperial 90 oven, trying to take out the circle element to test if it's fucked or not and replace (fan spins, no heat). The bolts holding it in look more like slightly hex rivet heads than bolts (and I can't get a grip with socket set or spanner). Do I need a special tool or do they look like rivets? I'm assuming I have to take the entire fucking oven apart if they are, in which case I'll have to get a gas safe engineer in as the gas hose is too short to pull the whole range out.