You are reading a single comment by @russmeyer and its replies.
Click here to read the full conversation.
russmeyer-
Thanks for the compliments.
Flaps are made from 2mm thick rubber sheet off eBay. A 300x300mm sheet did all 3 flaps with spare enough for an extra one. Attached the rear flap by drilling and zip ties, the front is bolted using the bolts for the stays and the scobleflap is attached to the bolt that attaches to the chainstay bridge. Only downsides are that I Could maybe do with 3mm rubber as the scobleflap is a little flappy, but due to it being in front of the tyre hasn't been sucked in yet, and also it says the type of rubber has poor resistance to oil, so not sure how it will degrade over time with oily spray from diesel etc on roads.
Link to rubber below:
nott_mike
Finished my 650b Cotic Escapade this week, lots of fun to ride and so floaty! Christened it on a trip to Aldi where it capably handled a full front loading of assorted tins and meats. Went tubeless today, currently have a very slowly leaking rear but the front seems all good. Overall I'm enjoying it a lot!! Just deciding whether to spend a bit more and go all black on the components or not as it was a bit of a parts bin build.