You are reading a single comment by @tomsvoboda and its replies.
Click here to read the full conversation.
-
Sounds awesome mate, really looking forward to the end result. Were the mounts by PMW? Seen they do some nice ones. Also, were they pre mitred or is Quirk doing that for you? Sorry for all the questions, just very interested in all of this.
The drops look good, they do take a bit of adjusting to though especially when used to risers ;) T
tomsvoboda
Nice_Ben
So got hold of steel removable mounts for rob quirk to braze on, going for brass brazing, should be simple and fairly neat. Mount will remove up to the boss so I'll have some boss on the frame but should look clean.
Going for internal cable routing on underside of the top tube which I'll seal later on in the year again with quirks helps to prevent too much water getting in (for now it will just be 2 small holes rather than a sealed channel in the top tube)
Wheels are setup now with tyres, tubes and freewheel and drops are on! Looking odd but awesome. Goes in to quirk tmr for the work do fingers crossed should have it back Monday ready to wrap the bars and take it for a spin