Home DIY

You are reading a single comment by @Airhead and its replies. Click here to read the full conversation.

•

bashthebox

Anyone used a router table much?
I'm trying to use it to cut box joints in 18mm ply... made a lovely jig and everything.
My problem is that the bit is delaminating the ply, and also kicking the work piece around a worrying amount. I'm using a 25mm bit - is this too big to use?

•

Airhead in reply to @bashthebox

25mm does sound like a large bit. I'm not sure that using ply is helping either, can't remember routing ply in 25 years of joinery! It's highly likely to delaminate if you are routing it. Is it high end furniture quality ply or ply shuttering?

About

Avatar for Airhead @Airhead started