You are reading a single comment by @HHC and its replies.
Click here to read the full conversation.
-
Ha, I wish. I beleive it was found by @kenzo on reddit here.
If you're asking to gather details of the flange manking process for your GT then I'd look here. I think it bascially consists of adding filler to (existing) thin metal flanges.
I think @young_gun had an idea of how the picture above was done though bear in mind that it would make it super heavy.
HHC-
Thanks! I have looked through @monoglaze 's restoration thread, but it seemed like he didn't actually make the metal bits from what I can tell...
I'd think for some areas (like between seat tube and stays) I would want a couple pieces of sheet metal, rather than just one with loads of filler... also wondering whether aluminium is really the best material for that (and where to source it)?
jdmitch
Where is that last photo from? your own handiwork @HHC ?